Air Cooled Condensers

Enhanced Design and Performance

Air Cooled Condensers

Air Cooled Condenser A-Frame

MASH System
The primary design for vacuum air-cooled condensers is based on the MASH concept. Steam is delivered to the condenser through a steam duct and manifold. It flows downward across two or three rows of finned tubes. Condensate is collected in bonnet header boxes connected to a hot water tank. Non-condensable gases flow upward through a deflegmator row for final condensation.

  • Meets most API 661 (ISO 13706) and ASME Section VIII, Division 1 requirements
  • U-stamped when required by the end user
  • Optimized selection for plot plan restrictions using Groovy fins

Single Row System
The Single Row System consists of aluminum-coated steel flat tubes with aluminum fins brazed to them. The solder filling the gap between the fin base and the core tube provides excellent heat transfer properties.

  • Low steam-side pressure drop for improved vacuum conditions and reduced condensate subcooling
  • Optimal use of the entire cooling surface by avoiding low-flow areas
  • Highest resistance to freezing

A-Tube System
The A-Tube System consists of elliptical bare tubes with rectangular carbon steel fins. Heat transfer is optimized through hot-dip galvanizing. The gap between the fin base and the tube is completely filled with zinc to ensure excellent heat transfer properties.

  • Hot-dip galvanizing provides outstanding corrosion protection
  • Suitable for both vacuum operation and pressure condensers subject to PED or ASME Section VIII, Division 1 requirements
Air Cooled Condenser A-Frame

Air Cooled Condensers

A wide range of applications

Check out our other categories